NEW PRODUCTS ARE HERE! CHECK THEM OUT.
Stores Cart

Distortion from the system

Make sure the levels have been set properly.
If the levels are not set properly, performance will suffer. Follow these guidelines when setting levels:

  1. Check the signal LED to make sure the input trim level is sufficiently high. The LED should be solid green, indicating a strong signal
  2. If the LED is not solid green, increase the input trim level, stopping before the LED is red.
  3. When the input trim level is correct, increase the channel volume and master volume to the desired levels.

Make sure no unwanted processing has been applied.
Disable any unwanted reverb, delay, compression, gating, EQ effects (zEQ and Parametric EQ) or all effects (FX mute on affected channel).