NEW PRODUCTS ARE HERE! CHECK THEM OUT.
Stores Cart

SoundLink® around-ear Bluetooth® headphones

Sold from 2015 – 2015

NOT YOUR PRODUCT?
Help us provide the best support by confirming your product below
Select your product
Product image
SUPPORT OPTIONS FOR
Loading
SEARCH
Enter a search term in the field above.
Nothing found. Please enter a valid search (e.g. connection help, no audio from headphones etc.).

Replacing the ear cushions

The pads on the earcups of your headphones can be replaced if they wear down over time. Find out how to attach a new set of ear cushions to your headset to ensure the best acoustic seal and comfort.

Snap the edges of the earcup cushions on to the earcups.

On the inside rim of the earcup, there are small tabs. Slide the edges of the earcup cushions under each of these tabs, then press all the way around the edges to snap the cushions in place.

Pulling off the ear cushions Putting on the ear cushions

To remove and replace ear cushions:

  1. Disconnect the Bluetooth® module from the earcup
  2. Grasp a side of the ear cushion and pull it up and outward to remove it. (Tip: Do not remove the material that covers the speaker)
  3. On the back of the ear cushion, fit the mounting flange inside the rim of the earcup
  4. Gently push on the edges of cushion to snap it into place.
Was this article helpful?
Submit
Thank you for your feedback!