Enable/Disable channel insert functionality

• To prevent pops and feedback, we recommend making all your connections before powering on your system and then the wireless transmitter
• It's important to use a proper insert cable, with a single ¼" TRS connector on one end, and two ¼" TS connectors on the other end
• Do not connect an instrument or other audio source with a standard ¼" cable when a wireless transmitter is connected, as audio will not play from either the wired or wireless source

After you have made your connections, powered on your system and the wireless transmitter:

1. Press and hold the channel control for either Channel 1 or 2 until the additional controls menu appears on the channel display.
2. Rotate the channel control to highlight "Insert," then press the channel control to select it.
3. Rotate the channel control to highlight your preferred setting, then press to select it:
   • Auto (default): When a wireless transmitter is powered on and connected to this channel, the 1/4" (6.35 mm) TRS channel input is converted into a series effects loop
   • Off: When a transmitter is powered on and connected to this channel, the system ignores signals from the channel input
4. Press and hold the channel control until the additional controls menu disappears.